Re: Spindle will not respond to an M3 command
Posted: Fri Feb 19, 2021 11:17 pm
Teco Fluxmaster 100.
I got the spindle working, You pointed me in the right direction. Apparently, the VFD had been replaced and someone halfway installed the one that is in it and never really got it working right. Now, when I issue M3 or M4 it works as it should.
so I tried running a program and it starts running, Spindle turns on, Tool moves toward the part, then it all the sudden runs in the -x direction hard and I get a "410 X axis(2) Position Error."
I am really starting to question my sanity at this point.. Every time I have encountered an issue and fixed it I am faced with another one. This is really starting to get old.
The Spindle is perfect now, works exactly as it should. Any Ideas on the 410 error?
Youtube Video:
Program I ran is attached. (1001.nc)
I got the spindle working, You pointed me in the right direction. Apparently, the VFD had been replaced and someone halfway installed the one that is in it and never really got it working right. Now, when I issue M3 or M4 it works as it should.
so I tried running a program and it starts running, Spindle turns on, Tool moves toward the part, then it all the sudden runs in the -x direction hard and I get a "410 X axis(2) Position Error."
I am really starting to question my sanity at this point.. Every time I have encountered an issue and fixed it I am faced with another one. This is really starting to get old.
The Spindle is perfect now, works exactly as it should. Any Ideas on the 410 error?
Youtube Video:
Program I ran is attached. (1001.nc)