Drake Lathe ATC

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Post Reply
gttool
Posts: 9
Joined: Wed Oct 28, 2020 6:17 am
Acorn CNC Controller: No
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: No
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: none
Location: Sydney Australia

Drake Lathe ATC

Post by gttool »

Has anyone had any experience with the Drake tool changers ?
Looking at purchasing one for this current build
Have attached catalog ,mechanical and electrical details
under the impression that power is applied,
Tool changer rotates till selected tool prox is activated
Power is released and the motor then reverses and locks
Geoff
Attachments
21170ncturret.zip
(3.06 MiB) Downloaded 12 times
martyscncgarage
Posts: 6686
Joined: Tue Mar 28, 2017 12:01 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: Yes
CPU10 or CPU7: Yes
CNC Control System Serial Number: none
Location: Mesa, AZ

Re: Drake Lathe ATC

Post by martyscncgarage »

gttool wrote: Mon Nov 16, 2020 4:10 am Has anyone had any experience with the Drake tool changers ?
Looking at purchasing one for this current build
Have attached catalog ,mechanical and electrical details
under the impression that power is applied,
Tool changer rotates till selected tool prox is activated
Power is released and the motor then reverses and locks
Geoff
I seem to remember that Centroid used to sell a lathe with such a changer. I don't think it would be an issue.
See the attached schematic, it might be the correct one. Perhaps Marc (cncsnw) can confirm.

Marty
Attachments
S14724.r4.pdf
(293.28 KiB) Downloaded 12 times
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
cncsnw
Posts: 1604
Joined: Wed Mar 24, 2010 5:48 pm

Re: Drake Lathe ATC

Post by cncsnw »

Yes, it looks like that wiring diagram matches the turret closely enough.
Post Reply