Centroid Community CNC Support Forum

hello everyone. i just upgraded my m15 to a new allin1 dc. i do not have my serial number from under the cover but do not think it is relevant to this question.

i am trying to set up my notepad++ per the tech bulletin and the associated youtube video from centroid.

i have followed every step to the T.

i unzipped the documents to my cncm folder.

i changed the compile.mill.txt to compile.cmd

and when i try to execute the compile.cmd and it says file not found.

do i need to point notepad++ to my cncm folder? if so, how do i do that?

thx

You need to open a PLC file from the cncm directory.

can you point me to the instructions on how to do that in notepad++? as you can see in the picture i had the instructions open and was following them. i do not know how to select a directory in notepad++. i just did what was on the instructions and never saw an option to select a certain directory.

Place the PLC program in the CNCM directory, open with notepad++

Here is more information:
https://www.youtube.com/watch?v=7WiEJiQ ... i2WKIedQlQ