Centroid Community CNC Support Forum

I am setting up a new Oak with AutomationDirect SVA-2100. I can't get pass #3 Drive Fault s error. I've swapped the encoder cables on the Oak and the error stays on #3.

Is it wired correctly?

A common error is to forget to connect 24VDC to H2.

To guess at anything beyond that, we would have to see a Report; some pictures (of the wiring and of the Alt-i screen); and the wiring diagrams.

cgspecialmachine wrote: ↑Wed Nov 04, 2020 4:52 pm I am setting up a new Oak with AutomationDirect SVA-2100. I can't get pass #3 Drive Fault s error. I've swapped the encoder cables on the Oak and the error stays on #3.

I moved this post from the Acorn forum