Is it possible to update a HURKO M5 installing just an OAK cnc controller #13135?
I will use my own W10 PC and an acer touch screen, for now.
The machine runs( I don´t use it) but I want to replace the old operator control console.
3 - axis - Baldor MTE-4535-SPECIAL dc servo ENCODER 500L
3 - 1993 servo dynamics AW1450-
I do appreciate in advance any help and time on this matter.
1996 HURKO M5 - OAK cnc controler #13135
Moderator: cnckeith
-
- Posts: 3098
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: 1996 HURKO M5 - OAK cnc controler #13135
It depends. Do the AW1450 drivers have servo passthru capability? If not, you should look at the AllIn1DC and drive the motors directly. In either case you will need to replace the 500 line encoders with at least 2000 line ones.
Post a link to the motor and drive manuals and some photos of the machine itself. You also didn't mention anything about the spindle drive. Does it take a 0-10V analog signal to control speed?
We'll need a lot more information and photos to help you make a decision.
Post a link to the motor and drive manuals and some photos of the machine itself. You also didn't mention anything about the spindle drive. Does it take a 0-10V analog signal to control speed?
We'll need a lot more information and photos to help you make a decision.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
-
- Posts: 9914
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Mesa, AZ
Re: 1996 HURKO M5 - OAK cnc controler #13135
Please follow and supply the information in this post:
viewtopic.php?f=64&t=383
I'm with Tom, DC brush servos? If so, All in One DC with new encoders. I did a video series on All in One to give you an idea of what is involved.
viewtopic.php?f=64&t=2421
Marty
viewtopic.php?f=64&t=383
I'm with Tom, DC brush servos? If so, All in One DC with new encoders. I did a video series on All in One to give you an idea of what is involved.
viewtopic.php?f=64&t=2421
Marty
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
We can't "SEE" what you see...
Mesa, AZ