Renishaw MP11 Probe Setup

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

BodeRacing
Posts: 75
Joined: Sat May 16, 2020 12:40 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: No
Oak CNC controller: Yes
CNC Control System Serial Number: 102849
DC3IOB: No
CNC12: No
CNC11: Yes
CPU10 or CPU7: No

Re: Renishaw MP11 Probe Setup

Post by BodeRacing »

Aly-Tek wrote: Mon Nov 02, 2020 9:27 pm
Hi BodeRacing, That's the same setup I'm trying to install. But it looks like you've only used 8 pins and the Renishaw OMI-2T has 13. Any chance you could share the wires and pinouts you used and any install notes I need to be aware of? It would be very much appreciated ;)

Many thanks,
Stephen
My comments:

- - I need to make some changes. Atrump did not enable tool touch off detect so I did not use it. I did not think it existed in the control, but it does. Parameter was not enabled. The folks on this board helped me figure it out. I need to add it and haven't had the chance yet.

- - I should of spent the money to buy an I/O expansion module. I still might. So I kind of cheated. I would of done more of it in the PLC if I had more outputs available.

- - I did not take the time to read the PLC programming instruction manual. So I kinda winged it on past experience. Not sure the programming is what it should be but it works.

- - I used AUX buttons to enable the spindle and tool touch off probes. See the PLC program for details.

- - JB is the junction box I added at the probe connector.

See if my stuff makes any sense to you...............
Attachments
report_1116170498_2020-10-27_19-08-14.zip
(2.33 MiB) Downloaded 134 times
Renishaw Probe Wiring rev May 15 2020.pdf
(39.01 KiB) Downloaded 117 times
Drawings PDF Version rev May 27 2 2020.pdf
(7.87 MiB) Downloaded 135 times
Aly-Tek
Posts: 16
Joined: Mon Nov 02, 2020 7:56 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: Yes
CNC Control System Serial Number: A900869
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
Location: Brisbane, Australia
Contact:

Re: Renishaw MP11 Probe Setup

Post by Aly-Tek »

Thanks for the details BodeRacing :) I'm still in the process of my initial retrofit and post in here when it's all fitted and tested ;)
Many Thanks
Stephen @ Aly-Tek :D
Post Reply