M400 control freezing up when jogging

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

jake2465
Posts: 35
Joined: Tue Aug 28, 2018 12:53 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: No
Oak CNC controller: Yes
CNC Control System Serial Number: 103298
DC3IOB: No
CNC11: Yes
CPU10 or CPU7: No

Re: M400 control freezing up when jogging

Post by jake2465 »

Here is a picture of the cabinet.
Attachments
picture.jpg
martyscncgarage
Posts: 9912
Joined: Tue Mar 28, 2017 12:01 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC12: Yes
CNC11: Yes
CPU10 or CPU7: Yes
Location: Mesa, AZ

Re: M400 control freezing up when jogging

Post by martyscncgarage »

jake2465 wrote: Thu Jun 11, 2020 1:03 pm Jefco MSI from West Alexandria Ohio did the installation for me. When the install was being performed, I was informed that they were much more used to installing Yaskawa servos with their retrofits and the only Estun servo drive installs they performed before my retrofit was with Acorn boards. In other words, they had not had to tune a Estun system with PID before because they had only done step and direction with them in the past. I was their first customer with that setup according to them.

The cabinet looks quite nice and professional. Cables and wires have been routed in conduit wherever possible.
I think you should probably go back to MSI. If they purchased the Estuns from Centroid, they could get support from Centroid in tuning.
It sounds like you paid them for a service. They should see it through...
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
Post Reply