Bridgeport Torqcut 22 Rebuild and Oak Retrofit

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

AshG
Posts: 21
Joined: Fri Nov 30, 2018 12:35 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: none
Contact:

Re: Bridgeport Torqcut 22 Rebuild and Oak Retrofit

Post by AshG »

Thanks Marty. It's been a lot of work, but I got to a point where I just decided I may as well make it good as new. Hopefully it will run and last for a very long time. I can't wait to get the centroid setup on it, so it's the same as my other machine with acorn. the Bridgeport control was ok but it was old and clunky, it was a pain with it being dos too, yeah dos is easy but it just doesn't interact well by today's standards. I want to be able to have the machine on the network, monitor remotely and all the fancy stuff 🤣🤣
Post Reply