motor tunning

[pablocnc]

Please, I need that you help me with the last to finished the connections, my machine is connecting in this moment, buy i have a problem, I don`t now the form of tunning my motors, because my motors jump a lot when i turn off from keyboard.

I have a cuestion, i have installed win7 version in spanish, you belive that i have change the system by win7 version english?

were often slow in getting plc ok, this shows a problem?

thank you

[CNC-Global]

For the CNC11 software following is the procedure for Language and Auto tuning

For the Language Please go in to the F1(setup)---->F3(config)---->F3(Parms)

set parameter 7 to 2 (for spanish Language) as in the picture


Now for the Auto Tune Please go in to the F1(setup)---->F3(config)---->F4(PID)----->F5(Tune)

After F5 Key Pressed you see the Screen

Press cycle start or ALt+S key to run the Atuo tune procedure

That procedure will autotune all three axis

Auto tune automatically calculate Ka ,kv kg ,acceleration and Max velocity of each axis

I hope this will help you

[pablocnc]

Thanks for you response, but, i forgot to write that my software is mach3, , please, if you can help me with the tunning my motors but to mach3 system..

I am sorry...

Thanks

[pablocnc]

Thanks for you response, but, i forgot to write that my software is mach3, , please, if you can help me with the tunning my motors but to mach3 system..

I need the information, please, if some people have the configuration, please help me
I am sorry...

Thanks