Hi looking at putting cnc controls on a 1978 Bridgeport mill table is 9x42.
Would not need the pc or lcd have spare one.
Looking at the Digitizing option that would be so handy. Also can it be added later on ?
Mill would need ball screws.
Just what would it take $$ to make this happen.
Most of the time cutting Alum or Steel.
Link to some parts made in past on Mill/Drill http://www.hobbiezones.com/page14.php
Also would anyone in the Iowa area have one to look at ?
Thank you
Bridgeport mill 9 x42
Moderator: cnckeith
-
HobbieZones.com
- Posts: 1
- Joined: Tue May 17, 2011 3:10 pm
- Allin1DC CNC Controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Bridgeport mill 9 x42
(Note: Liking will "up vote" a post in the search results helping others find good information faster)