We recently purchased your DM45 Mill and are ready to wire it in. We cannot however find any info anywhere that shows exactly how to do this. The 120v is no big deal, but the 220 single phase, to be converted to 3 phase? I believe we
just run the 2 hots to L1 and L2 on the VSD, but would like some confirmation!
**RESOLVED** Wiring DM45 Mill
Moderator: cnckeith
Re: Wiring DM45 Mill
Because the 220VAC is used for the GS2 inverter, you can wire it to any 2 of the 3 incoming legs.