M 40 to remote pc ?
Moderator: cnckeith
-
Mansuper
- Posts: 10
- Joined: Wed Mar 14, 2018 1:17 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: Yes
M 40 to remote pc ?
Need some advise on hooking my M40 to a remote PC. How do I do it and what type cable is needed. The remote PC has a 9 pin male plug in and a 25 pin also.
-
Centroid_Tech
- Posts: 286
- Joined: Thu Mar 18, 2010 2:24 pm
Re: M 40 to remote pc ?
I am assuming that since you are mentioning the 9 pin and the 25 pin connectors, you are trying to send programs to the M40 control via the RS-232 port, correct. If so, the attached tech bulletin may help you out. Some systems required an additional software, CNC7DNC, which I have attached the manual for that software.
- Attachments
-
- CNC7DNC.pdf
- (145.86 KiB) Downloaded 98 times
-
- 030 RS232.pdf
- (11.14 KiB) Downloaded 107 times
When requesting support, please ALWAYS post a current report. Find out how to take a report from your Acorn, CNC11 or CNC10 system here: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
If your question is PLC, Macro or program related, please also post a copy of the program or macro as well.
Without the above information we may not be able to help and/or reply until the required information is posted..
If your question is PLC, Macro or program related, please also post a copy of the program or macro as well.
Without the above information we may not be able to help and/or reply until the required information is posted..
-
Mansuper
- Posts: 10
- Joined: Wed Mar 14, 2018 1:17 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: Yes
Re: M 40 to remote pc ?
Thanks you have been a big help as always..