M40 tapping
Moderator: cnckeith
-
- Posts: 10
- Joined: Wed Mar 14, 2018 1:17 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: Yes
M40 tapping
Just got a 1989 Atrump bed mill with M40 control . I’m trying to tap with a tension compression tool holder , when programing in Shop floor I Press F3 and fill in all info check F8 and graph shows the tap tapping . But when I run it the program shuts down . I see in the M Series manual that tapping may have been an opposition . If so can I add it now? Thanks for any help ........
-
- Posts: 286
- Joined: Thu Mar 18, 2010 2:24 pm
Re: M40 tapping
Please email a current report as well as a configuration backup of that system as explained in the CNC7 section of the attached tech bulletin to support@centroidcnc.com. I am assuming that as old as that system is, you are most likely running CNC7 which is a DOS based control. If you are running CNC10 which is a Linux based control, please follow that section of the tech bulletin.
- Attachments
-
- 193 Generating Report.pdf
- (5.58 KiB) Downloaded 91 times
When requesting support, please ALWAYS post a current report. Find out how to take a report from your Acorn, CNC11 or CNC10 system here: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
If your question is PLC, Macro or program related, please also post a copy of the program or macro as well.
Without the above information we may not be able to help and/or reply until the required information is posted..
If your question is PLC, Macro or program related, please also post a copy of the program or macro as well.
Without the above information we may not be able to help and/or reply until the required information is posted..
-
- Posts: 10
- Joined: Wed Mar 14, 2018 1:17 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: Yes
Re: M40 tapping
Ok thanks I’ll give a try to generate a report and forward to you soon.....
-
- Posts: 10
- Joined: Wed Mar 14, 2018 1:17 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: Yes
Re: M40 tapping
Ok thanks I’ll give a try to generate a report and forward to you soon.....it is running CNC7