I have a Lagun mill with All in one DC, NUC PC and CNC12. This setup is less than l year old. It started up with no issue a week ago. Today it will not start.
The monitor comes on and the NUC start screen appears. It then either goes to a blank screen with a notice that there is no HDMI feed or a page that advises that Windows 11 is not working correctly. There are several options for diagnosis and repair. None of them have worked. Is there a battery somewhere that ran down?
startup fail <resolved>
Moderator: cnckeith
-
WeirdEngineering
- Posts: 4
- Joined: Sun Nov 26, 2023 2:39 pm
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: Yes
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 104762
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
startup fail <resolved>
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
WeirdEngineering
- Posts: 4
- Joined: Sun Nov 26, 2023 2:39 pm
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: Yes
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 104762
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: startup fail
I followed the Intel troubleshooting guide for the NUC and it seems to be a bad HDMI port. Switching the cable to a different port appears to have solved the problem.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
cnckeith
- Posts: 7929
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: startup fail <resolved>
thanks for reporting back
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
(Note: Liking will "up vote" a post in the search results helping others find good information faster)