AsdB3 precision parameters for OAK

[aamir]

Hello
Any one has ASD-B2 or B3 oak precision parameters?

[centroid467]

I have attached parameters and a wiring connection list for Delta ASD-B3A-xxxx-E EtherCAT drives with Oak. They should apply to to other ASD-B3A models but the wiring will be different for ASD-B3(A)-xxxx-L models since those have a 44 pin connector. I have not tested the load meter feedback settings yet. I did do a small amount of testing with these parameters on the bench and a single machine axis.



I believe the ASD-A2 tech bulletin parameters may give some hints for setting up ASD-B2 drives. ASD-A2 TB: https://www.centroidcnc.com/dealersuppo ... ds/264.pdf

[aamir]

Thanks
Rest I will do

[ChristianBrischetto]

Hi,
I'm using a delta ASD-B3-xxxx-L servo drive and was wondering if the above parameters worked for your installation and if you had any suggestions