HELP ME

[Scorpion3]

my machine keeps getting stuck, when I load a program it doesnt want to pull in the H parameter, Doesnt matter if I am loading a intercon file or g code when I hit the run button it says there is a z axis problem and on the screen the after the T or tool call out the Hieght or H call out is blank, it is a intermitten problem and sometimes takes hours to trick the machine back into pulling in the data so its knows what tool offset it has to work with. Very frustrating and costing alot of time.

[cncsnw]

The reason the status window still says "H---" is because it has not actually run the program that far. It has read ahead far enough to see a problem, and it has reported the problem and cancelled the job.

I don't see a G43 in your program. Without a G43, H doesn't do anything.

[Scorpion3]

thanks