Morning gang. Trying to run the eStop test on page 39. I mean, it works as described, but from what I can tell the Out1 relay is not pulled in to engage 24Vac to the coil? Is that supposed to work or is there some other output config setup I need to complete? Or do I remove the 'all faults clear' from a previous step... Hmmmm?
Thanks,
Jeff
RESOLVED DC-AIO/ CNT1 and eStop test. No CNT1 coil Vac.
Moderator: cnckeith
-
- Posts: 86
- Joined: Sat Dec 27, 2014 4:53 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
RESOLVED DC-AIO/ CNT1 and eStop test. No CNT1 coil Vac.
Last edited by countryguy on Thu Mar 05, 2015 12:20 pm, edited 1 time in total.
-
- Posts: 86
- Joined: Sat Dec 27, 2014 4:53 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Resolved- DC-AIO/ CNT1 and eStop test. No CNT1 coil Vac.
I issued the spindle stall removal, cycled the input 11 estop - and Wham! 24Vac on the contactor. All good! Thanks. Always fun to solve yourself.