OK... This upgrade is into the Lappy setup & prechecks and DCAio power up pre flight checks. Guide looks pretty darn good! Nice job. OK, Time to make this Mill sing on it's own! ;- ) Hope I can get some devoted quiet time this eve and tomorrow.
Thanks for all the help thus far
Jeff
OK... PowerUp time.
Moderator: cnckeith
-
- Posts: 86
- Joined: Sat Dec 27, 2014 4:53 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
-
- Posts: 86
- Joined: Sat Dec 27, 2014 4:53 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Re: OK... PowerUp time. -All Good- Whew!
OK, PC is communicating w/ the Dc-AIO No board errors. benchtest good! WHEW!!!!
-
- Posts: 436
- Joined: Mon Jul 18, 2011 9:57 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: OK... PowerUp time.
Nice Job! Glad to hear your retrofit is coming together.
When requesting support READ THIS POST first. https://www.viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
-
- Posts: 86
- Joined: Sat Dec 27, 2014 4:53 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
OK... I/O setups and Final Config time
Thanks! Appreciate it. Even the Encoder counts worked for all 3 axis out of the gate. Now that was a nice plus for me. I hate yanking those motors down, out, and apart.
OK, so now I'm going to check the E-Stop and Contactor and Limit Sw's , lube, spindle etc ....and then get into the final config!!!! So close. Thanks again for a great product thus far.
OK, so now I'm going to check the E-Stop and Contactor and Limit Sw's , lube, spindle etc ....and then get into the final config!!!! So close. Thanks again for a great product thus far.