Machine not set up notice at start .Machine homes , z+,x-,y+ and notice disappears . Spindle and lube not yet wired in , but disabled .
do i need to get the system test to complete ? Reports attached
Thanks Don
Machine not set up notice
Moderator: cnckeith
Re: Machine not set up notice
Yes, the "installation is not complete" message will go away once you have run the System Test to a successful completion.
-
dasme
- Posts: 7
- Joined: Sun Jul 15, 2012 2:39 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: A900283 ID 0807120528
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Re: Machine not set up notice
System test.out says : axis 1 invalid travel limt
Where are limits set and what should they be set at?
Where are limits set and what should they be set at?