Ok so I am wiring and doing checks and I get 170 vdc out of the cap board.
The install manual states it should be max of 130 vdc is this going to be ok at 170 ?
Thanks Jake
170 volt dc
Moderator: cnckeith
-
- Posts: 12
- Joined: Mon Sep 01, 2014 6:15 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: 1013141134
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
-
- Posts: 436
- Joined: Mon Jul 18, 2011 9:57 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: 170 volt dc
What is the revision on your install manual? We switched to 180V max cap-boards over a year ago. Please take at the Tech Bulletin below for specifics and serial numbers of when the switch happened.
http://www.ajaxcnc.com/downloads/Techni ... ns/269.pdf
http://www.ajaxcnc.com/downloads/Techni ... ns/269.pdf
When requesting support READ THIS POST first. https://www.viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
-
- Posts: 12
- Joined: Mon Sep 01, 2014 6:15 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: 1013141134
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Re: 170 volt dc
Ok thanks I was just making sure don't want to blow anything up.
The revision on the install manual is 2-18-2014
The revision on the install manual is 2-18-2014