Cnc11 4.14 version Alt+J display

[Abdullah Butt]

When I press Alt+J for axis jog its display is too large.
Difficult to read other DRO screen.
I am using window 10.
Anyone tell me how to resolve this issue.

[eng199]

For CNC11, most systems had a physical jog panel. That was the cure for any shortcomings of the ALT+J virtual panel. I would be surprised if there was any way to move or resize it, because I have never seen it done.

Your screen shot shows CNC12 software. This can work with the new virtual control panel. The ALT+J panel should be considered obsolete on CNC12. The new virtual control panel works nicely if you upgrade to a wide screen monitor.

[martyscncgarage]

Attached is a CNC12 (For Servo) Parameter Cheat Sheet. You can use it to turn on Virtual Control Panel (Provided as Matt says, you have a wide screen monitor)
Marty

[Abdullah Butt]

I got it's solution.
You just need to get a required BMP of jogpanel and paste it into
Cncm: /BMP folder and rename with last active jogpanel BMP.