Ether1616 Not Recognized

Moderator: cnckeith

Post Reply
martyscncgarage
Posts: 9912
Joined: Tue Mar 28, 2017 12:01 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC12: Yes
CNC11: Yes
CPU10 or CPU7: Yes
Location: Mesa, AZ

Ether1616 Not Recognized

Post by martyscncgarage »

If you have connected your Ether1616 properly:
1: Connect the CNCPC's PHYSICAL ethernet port to the ethernet switch
2: Connect Acorn and Ether1616 to the switch using the Centroid supplied shielded Ethernet cables and power supplies.
3: Start CNC12, you should get a message that an Ether1616 was detected:
Ether1616 Detected message.jpg
If you don't, but you can ping the IP address: 10.168.41.3

Post by eng199 » Wed Jun 01, 2022 5:43 am

IPv6 should be disabled for the on board Ethernet adapter.
This sometime causes problems with ETH1616 detection.

https://networking.grok.lsu.edu/article ... leid=17573


Here are some related posts:
https://centroidcncforum.com/viewtopic. ... it=eth1616
https://centroidcncforum.com/viewtopic. ... it=eth1616
https://centroidcncforum.com/viewtopic.php?f=61&t=1451
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
Post Reply