Mike...
Spin up a VFD controlled spindle using Acorn's 0-10v analog as the freq reference. You may see the need for the resistors then
CNC4PC C86ACCP for ClearPath SDSK servos
Moderator: cnckeith
-
Gary Campbell
- Posts: 2189
- Joined: Sat Nov 18, 2017 2:32 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: Acorn 238
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Bergland, MI, USA
- Contact:
-
Fredsan
- Posts: 72
- Joined: Wed Sep 27, 2017 3:07 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
- Location: The Netherlands
Re: CNC4PC C86ACCP for ClearPath SDSK servos
What is the voltage the C86ACCP gives to the drivers 24V or 5V?
-
arturod
- Posts: 23
- Joined: Fri Apr 03, 2020 6:42 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: CNC4PC C86ACCP for ClearPath SDSK servos
I made a post in our website explaining the basic process for setting this up:
https://www.cnc4pc.com/blog/post/configuration-c86accp
Note that I intentionally left out of those instructions covering some features that can be considered as Advanced and do create confusion. These are:
- Cable disconnect detection.
- Using the NO_FAULT signal from CNC12 to enable the C86.
- SOFT/HARD Servo Enable.
I also updated the REPORT.ZIP file to the current CNC12 version.
Mike, thanks for your comments. I wish I have been faster.
Arturo Duncan
https://cnc4pc.com
https://www.cnc4pc.com/blog/post/configuration-c86accp
Note that I intentionally left out of those instructions covering some features that can be considered as Advanced and do create confusion. These are:
- Cable disconnect detection.
- Using the NO_FAULT signal from CNC12 to enable the C86.
- SOFT/HARD Servo Enable.
I also updated the REPORT.ZIP file to the current CNC12 version.
Mike, thanks for your comments. I wish I have been faster.
Arturo Duncan
https://cnc4pc.com
Arturo Duncan
https://cnc4pc.com
https://cnc4pc.com