Could I just confirm that I have this right.
If I am going to run duel servos for my CNC router build and won't to have duel homing for squaring the gantry dose this mean I have to forgo having an A axis for a rotary setup
A axis with slaved y axis
Moderator: cnckeith
-
Gary Campbell
- Posts: 2190
- Joined: Sat Nov 18, 2017 2:32 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: Acorn 238
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Bergland, MI, USA
- Contact:
Re: A axis with slaved y axis
If you wish to have 4 motors that are software paired (i.e., for autosquaring) then there are no channels left for rotary.
If you wish to hardware pair (sistered signal wires) then adding a rotary is possible
If you wish to hardware pair (sistered signal wires) then adding a rotary is possible