DMM DYN4 Setup with Acorn

Moderator: cnckeith

Post Reply
martyscncgarage
Posts: 9912
Joined: Tue Mar 28, 2017 12:01 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC12: Yes
CNC11: Yes
CPU10 or CPU7: Yes
Location: Mesa, AZ

DMM DYN4 Setup with Acorn

Post by martyscncgarage »

If you are using DYN4 with Acorn, software revisions up to 4.18, you MUST go into the ADVANCED tab in the Wizard and check the boxes in front of ENABLE.

Reason being, is that DYN2 uses the DB25 for its signals and the DYN4 uses the header terminals on Acorn for its Axis signals. The ENABLE signals are OPPOSITE each other. So until Centroid separates the two, and gives them their own Radio button, you have to invert the ENABLE signal for DYN4 manually in the Advanced tab.

Marty
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
Post Reply