Page 7 of 7
Re: Quick Tip: IF you have Home/Limit Switches, here is an example and description on setting them up
Posted: Wed Mar 06, 2019 3:59 pm
by Dan M
tblough wrote: ↑Wed Mar 06, 2019 1:51 pm
Just be glad you don't have a CDO problem. It's like OCD, but the letters are in the correct order like they should be.
Haha I like that one Tom!! See you really do learn something new everyday.
Re: Quick Tip: IF you have Home/Limit Switches, here is an example and description on setting them up
Posted: Mon Apr 01, 2019 1:36 am
by Racedirector
Quick question on this subject....
I don't have a limit switch on Z yet, I have been just jogging Z to it's highest point and THEN I activate the homing sequence which in LinuxCNC would automatically set Z to Zero (0). Is that the same here for Acorn?
Cheers
Bruce
Re: Quick Tip: IF you have Home/Limit Switches, here is an example and description on setting them up
Posted: Mon Apr 01, 2019 7:18 am
by Gary Campbell
Racedirector wrote: ↑Mon Apr 01, 2019 1:36 am
Quick question on this subject....
I don't have a limit switch on Z yet, I have been just jogging Z to it's highest point and THEN I activate the homing sequence which in LinuxCNC would automatically set Z to Zero (0). Is that the same here for Acorn?
Cheers
Bruce
Yes it will, but don't underestimate the value of the Z homing/limit switch
Re: Quick Tip: IF you have Home/Limit Switches, here is an example and description on setting them up
Posted: Mon Apr 01, 2019 7:52 am
by Racedirector
Thanks Garry
Plans are afoot to get a proxy onto the Z, I need to sort out proper dust collection first and that has to wait until I move into my new house and get my large shed built
Cheers
Bruce