Facing One shot program

mrautom8 · Post by **mrautom8** » Tue Oct 17, 2023 9:05 pm

Hey Guys,
Just learning my newly built Acorn CNC Lathe converted Hardinge.
Is Facing and Radius one shot paid features? They don't do anything when I press them. Chamfer, Turning, Drill work but Radius and Facing don't do anything?
Thanks

suntravel · Post by **suntravel** » Tue Oct 17, 2023 11:02 pm

Pls send report file, I am sure two parameters are not set right.

Uwe

mrautom8 · Post by **mrautom8** » Wed Oct 18, 2023 3:01 pm

suntravel wrote: ↑Tue Oct 17, 2023 11:02 pm Pls send report file, I am sure two parameters are not set right.

Uwe

Hi Uwe,
Thanks in advance for any help. I just got back to the machine.
Attached is the report.zip.

mrautom8 · Post by **mrautom8** » Sat Oct 21, 2023 2:36 pm

Hi Uwe,
Any idea the on the 2 settings you were mentioning?
Vielen Dank

suntravel · Post by **suntravel** » Sat Oct 21, 2023 5:28 pm

Sorry, your parameters are ok, should work...
Is this page in the Wizard set up the same way?

Uwe

mrautom8 · Post by **mrautom8** » Sun Oct 22, 2023 1:00 pm

It appears the macros are assigned properly to these buttons. Perhaps I should check that the macros are where they are supposed to be when called by the buttons?

suntravel · Post by **suntravel** » Sun Oct 22, 2023 1:16 pm

Update to current 5.07 beta, maybe faster. This is the version Iam using currently on my lathe.

Uwe

Post by **cnckeith** » Wed Jan 24, 2024 3:22 pm

i moved this thread into the Acorn Forum

Centroid Community CNC Support Forum

Facing One shot program

Facing One shot program

Re: Facing One shot program

Re: Facing One shot program

Re: Facing One shot program

Re: Facing One shot program

Re: Facing One shot program

Re: Facing One shot program

Re: Facing One shot program