Wanted; turret encoder for Hardinge CHNC2

[lavrgs]

My encoder seems to work although I have some questions about the truth table. I had planned on taking off the magnet holder but the screw may have ben Loctited in...I wanted to spin the turret and see if the diagnostic lights worked for the 4 positions and they seem to work but not according to this table...my inputs are 19 20 21 22

[tblough]

If they don't match the table, swap the wires around until they do.

[lavrgs]

The table comes from the Centroid Retrofit of Hardinge dated 2004 - I consider it just a reference. Based on the fact it is using different INPUTs for the hall cells vs Todays ALLIN1DC, is not time to start swapping wire. I will have to position my turret to all the positions and compare what I get to the table shown above. I have started to fill out what my INPUTS produce but am not finished.
My assumption is that when I finish mapping my turret, the change to the table will be renaming the header line with the INPUTs that the current ALLIN1DC uses...i.e. INPUT 7 >>INPUT 19 etc.