SOLD
I have for sale the following items that are new and in the box. This is a motor/drive combo that is capable of both ~3000 RPM (via -10/+10 control) AND Step and direction positioning. Swap between the two is handled by a single input. Drive is 230V single phase
LeadShine ELM1000LH80F-SS 1kw Servo Motor
LeadShine ELP-RS1000Z Servo Drive
LeadShine Encoder Cable 1.5 meter
LeadShine Power Cable 1.5 meter
LeadShine "Test & Tune" cable
CNC4PC C89 R1 Interface Board This interface board converts Acorns 0-10v RPM signal and the FWD & REV signals into -10v - 0v - +10v control voltage for the servo drive in velocity mode.
Digital manuals for each component are included on thumb drive with the products. These were purchased for a lathe/indexer project that never came to fruition. ~$600 invested asking $400 OBO
Email: gcnc411@gmail.com to purchase or for more information
SOLD!!! Servo for Lathe C axis use
Moderator: cnckeith
-
- Posts: 2325
- Joined: Sat Nov 18, 2017 2:32 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: Acorn 238
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Bergland, MI, USA
- Contact:
SOLD!!! Servo for Lathe C axis use
Last edited by Gary Campbell on Wed Aug 02, 2023 12:59 pm, edited 1 time in total.
GCnC Control
CNC Control & Retrofits
CNC Depot Modular ATC kits
https://www.youtube.com/user/Islaww1/videos
CNC Control & Retrofits
CNC Depot Modular ATC kits
https://www.youtube.com/user/Islaww1/videos
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
- Posts: 2325
- Joined: Sat Nov 18, 2017 2:32 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: Acorn 238
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Bergland, MI, USA
- Contact:
Re: Servo for Lathe C axis use
If some one is on the fence, I can provide these components prewired, or prewired with an Acorn or AcornSIX
GCnC Control
CNC Control & Retrofits
CNC Depot Modular ATC kits
https://www.youtube.com/user/Islaww1/videos
CNC Control & Retrofits
CNC Depot Modular ATC kits
https://www.youtube.com/user/Islaww1/videos
(Note: Liking will "up vote" a post in the search results helping others find good information faster)