SOLD!!! Servo for Lathe C axis use

Moderator: cnckeith

Post Reply
Gary Campbell
Posts: 2250
Joined: Sat Nov 18, 2017 2:32 pm
Acorn CNC Controller: Yes
Plasma CNC Controller: No
AcornSix CNC Controller: Yes
Allin1DC CNC Controller: No
Hickory CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: Acorn 238
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
Location: Bergland, MI, USA
Contact:

SOLD!!! Servo for Lathe C axis use

Post by Gary Campbell »

SOLD

I have for sale the following items that are new and in the box. This is a motor/drive combo that is capable of both ~3000 RPM (via -10/+10 control) AND Step and direction positioning. Swap between the two is handled by a single input. Drive is 230V single phase

LeadShine ELM1000LH80F-SS 1kw Servo Motor
LeadShine ELP-RS1000Z Servo Drive
LeadShine Encoder Cable 1.5 meter
LeadShine Power Cable 1.5 meter
LeadShine "Test & Tune" cable

CNC4PC C89 R1 Interface Board This interface board converts Acorns 0-10v RPM signal and the FWD & REV signals into -10v - 0v - +10v control voltage for the servo drive in velocity mode.

Digital manuals for each component are included on thumb drive with the products. These were purchased for a lathe/indexer project that never came to fruition. ~$600 invested asking $400 OBO

Email: gcnc411@gmail.com to purchase or for more information
Attachments
IMG_20230531_125815538.jpg
IMG_20230531_123917860.jpg
IMG_20230531_123911386.jpg
IMG_20230531_123814667.jpg
IMG_20230531_123808414.jpg
Last edited by Gary Campbell on Wed Aug 02, 2023 12:59 pm, edited 1 time in total.
GCnC Control
CNC Control & Retrofits
https://www.youtube.com/user/Islaww1/videos
Gary Campbell
Posts: 2250
Joined: Sat Nov 18, 2017 2:32 pm
Acorn CNC Controller: Yes
Plasma CNC Controller: No
AcornSix CNC Controller: Yes
Allin1DC CNC Controller: No
Hickory CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: Acorn 238
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
Location: Bergland, MI, USA
Contact:

Re: Servo for Lathe C axis use

Post by Gary Campbell »

If some one is on the fence, I can provide these components prewired, or prewired with an Acorn or AcornSIX
GCnC Control
CNC Control & Retrofits
https://www.youtube.com/user/Islaww1/videos
Post Reply