Centroid Community CNC Support Forum

FOR SALE:

Used Yaskawa Sigma 5 servo motor
sgmgv-30a3a61

I have 4 if these motors. They are all in good working condition with no issues. I have run them all to check if they work and I can post videos of them running if interested. They come of a retrofited machine, but the machine wasn't used much and then ended up getting scrapped so the motors were pulled off.

$600 a motor + shipping. Will ship anywhere, I can give a quote if needed.

Do you have the Drives

TheKitMill wrote: ↑Thu Feb 09, 2023 11:39 am Do you have the Drives

I do, I also have a full Centroid kit for sale

https://ventura.craigslist.org/tls/d/ox ... 75763.html

Thanks for the link. I don't think the Sigma 5 will work for the Acorn six.

TheKitMill wrote: ↑Fri Feb 10, 2023 9:56 am Thanks for the link. I don't think the Sigma 5 will work for the Acorn six.

They actually will work with the Acorn just great with Step and Direction mode. Here is a link how to set them up with the Acorn:

https://www.centroidcnc.com/dealersuppo ... ds/297.pdf

Hi Thanks for the info. I just bought at auction two Haas Mills a VF-OE and a VF-4 both basket cases for rebuild . If I need to replace any motors I will keep your in mind.