Page 1 of 1

DC3IO

Posted: Mon Jul 19, 2021 10:06 am
by martyscncgarage
Perfect working condition. Removed from ATrump Maximill E216 Vertical Machining Center. This is the 12Amp version (4 wire turns on the current sensor) DC Brush servos were 29in lb. Picture of servo attached (Servo motor not included)
Machine was upgraded to current Centroid Motion Control System. You must know what you are doing and have a CNC Technician replace it for you. I service Centroid Controls. It is warranted against DOA. YOU MUST TEST Your DC Brush Servo motors BEFORE installing the DC3IO to ensure that it wasn't a bad motor that damaged your DC3IO, Per Centroid Tech Bulletin TB155. (I do have the 3 Centroid (SEM) Servos available, they are clean and VERY lightly used, the machine saw no production.)

$625obo and I will include shipping in US48

DOA Warranty Only.
Any questions, do not hesitate to ask.
Will not ship out of US.
I can expedite ship at your expense.

Marty