DC3IO

Moderator: cnckeith

Post Reply
martyscncgarage
Posts: 8608
Joined: Tue Mar 28, 2017 12:01 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: Yes
CPU10 or CPU7: Yes
CNC Control System Serial Number: none
Location: Mesa, AZ

DC3IO

Post by martyscncgarage »

Perfect working condition. Removed from ATrump Maximill E216 Vertical Machining Center. This is the 12Amp version (4 wire turns on the current sensor) DC Brush servos were 29in lb. Picture of servo attached (Servo motor not included)
Machine was upgraded to current Centroid Motion Control System. You must know what you are doing and have a CNC Technician replace it for you. I service Centroid Controls. It is warranted against DOA. YOU MUST TEST Your DC Brush Servo motors BEFORE installing the DC3IO to ensure that it wasn't a bad motor that damaged your DC3IO, Per Centroid Tech Bulletin TB155. (I do have the 3 Centroid (SEM) Servos available, they are clean and VERY lightly used, the machine saw no production.)

$625obo and I will include shipping in US48

DOA Warranty Only.
Any questions, do not hesitate to ask.
Will not ship out of US.
I can expedite ship at your expense.

Marty
Attachments
DC3IO.jpg
DC3IO-1.jpg
DC3IO-2.jpg
DC3IO-3.jpg
Centroid Servo.jpg
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
Post Reply