I am currently working on a CR Onsrud retrofit with acorn. In the interest of sticking with 4 axis and saving myself some width in the shop, as this thing is massive, I have decided not to use the turrets that I have. I acquired 2 of these turrets with this auction lot. They are pretty complete save, for the motor to drive them. Requires something with a 34 frame. Stepper or closed loop anything works just fine. Has a 10-1 gear reduction as part of the assembly. Currently has a 63f setup on it, but this can be changed to anything.
This thing is way over built. If you intend on putting it on a light weight gantry, its not for you.
Make offer, again I have 2 available.
Dennis@thehomesteadworkshop.com
12 tool ATC turrette
Moderator: cnckeith
-
- Posts: 26
- Joined: Thu Apr 04, 2019 10:24 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
12 tool ATC turrette
Maker1970
"You lie to your friends, and I'll lie to mine. Let's not lie to each other"
"You lie to your friends, and I'll lie to mine. Let's not lie to each other"
(Note: Liking will "up vote" a post in the search results helping others find good information faster)