Centroid Community CNC Support Forum

Hey I have 2 of those motors if you still need one. They look like they are new.

Chaz wrote: ↑Mon Dec 16, 2024 12:15 pm Ive got a Hardinge CHNC with failed electrics. Not sure what it has yet, might have a replacement for you, will check this week. Why not just replace with modern AC servos?

Funds....also this is equipped with an allin1dc, are AC servos even compatible?

Rensoc wrote: ↑Wed Dec 25, 2024 8:33 pm Hey I have 2 of those motors if you still need one. They look like they are new.

I sent you a PM.

Skunk wrote: ↑Mon Jan 06, 2025 11:09 pm

Chaz wrote: ↑Mon Dec 16, 2024 12:15 pm Ive got a Hardinge CHNC with failed electrics. Not sure what it has yet, might have a replacement for you, will check this week. Why not just replace with modern AC servos?

Funds....also this is equipped with an allin1dc, are AC servos even compatible?

I dont know but dont think so. Ive not had time to look and its winter here - shout if you need help on sourcing a motor. Are you UK / USA based?

Chaz wrote: ↑Tue Jan 07, 2025 2:48 am

Skunk wrote: ↑Mon Jan 06, 2025 11:09 pm

Chaz wrote: ↑Mon Dec 16, 2024 12:15 pm Ive got a Hardinge CHNC with failed electrics. Not sure what it has yet, might have a replacement for you, will check this week. Why not just replace with modern AC servos?

Funds....also this is equipped with an allin1dc, are AC servos even compatible?

I dont know but dont think so. Ive not had time to look and its winter here - shout if you need help on sourcing a motor. Are you UK / USA based?

I am in Northeast Pennsylvania.

Skunk wrote: ↑Mon Jan 06, 2025 11:09 pm

Chaz wrote: ↑Mon Dec 16, 2024 12:15 pm Ive got a Hardinge CHNC with failed electrics. Not sure what it has yet, might have a replacement for you, will check this week. Why not just replace with modern AC servos?

Funds....also this is equipped with an allin1dc, are AC servos even compatible?

Not easily! You could try OpticDirect or AC/DC drives through the DriveBus interface. Although, that is probably going to add up to the price of an Oak or Hickory so it does not make much sense in most cases.

Thanks all. Bought two motors and a pendant from Rensoc. Got them on hand next day! These have to be unused. Super excited to get working on the Hardinge now.