KBMG 212D with SIMG, CNC4PC C89, Acorn Setup

Moderator: cnckeith

Locked
martyscncgarage
Posts: 9912
Joined: Tue Mar 28, 2017 12:01 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC12: Yes
CNC11: Yes
CPU10 or CPU7: Yes
Location: Mesa, AZ

KBMG 212D with SIMG, CNC4PC C89, Acorn Setup

Post by martyscncgarage »

Quickie video to show how to wire and setup the KB Electronics KBMG 212D with its SIMG signal Isolator to a CNC4PC C89 analog control board to Centroid Acorn.

C89 basically will take the Centroid ACORN 0-10VDC Spindle Analog Output and with a VFD Direction Input, will convert the output to +/- 0-10VDC for use with drives that require both a positive and negative 0-10VDC input such as many DC drives.

Be sure to follow the KB Electronics KBMG 212D and SIMG manuals to set your DC Brush motor up correctly (Or your drive manufacturer's manual)
Be sure to fuse the AC side and the DC Brush side properly. HIGHLY recommended that you run the DRIVE ENABLE line through an Estop contactor contact so that when there is a fault or you hit the Estop contactor, it will stop your spindle (opening the enable circuit)

Information for reference only. Its up to you to integrate and wire things up properly.
CNC4PC C89: https://www.cnc4pc.com/c89-10vdc-analog ... board.html
KB Electronics KBMG Manual: https://acim.nidec.com/drives/kbelectro ... ashx?la=en
KB Electronics SIMG Manual: https://acim.nidec.com/drives/kbelectro ... ashx?la=en

Wiring Diagram Sketch:
C89 KBMG-212D SIMG to Acorn _20210801_073331.jpg
Video:
Attachments
C89 KBMG-212D SIMG to Acorn _20210801_073320.pdf
(743.42 KiB) Downloaded 197 times
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
Locked