Is there a "trim" setting in Acorn to adjust treat our to acutal movemetn
Posted: Tue Mar 26, 2024 11:40 am
I have a Unimat small jewelers lathe project.
I have everything installed and x and z are moving in the correct directions.
Where is Acorn set up do I go to set up the movement to of the x & z to match the movement displayed on the screen?
I have everything installed and x and z are moving in the correct directions.
Where is Acorn set up do I go to set up the movement to of the x & z to match the movement displayed on the screen?