Centroid Community CNC Support Forum

Running Acorn Lathe Ultimate on Lathe

When I push 100% it decreases spindle RPMs.

Since it started doing this it is also not reading my encoder correctly I. The software and reads +215 but the lathe is actually running at 2200 on it’s readout!

Thoughts?

Encoder bad?

The 100% key commands 100% of programmed (via an Snnnn) command, or 50% of maximum speed if running in manual spindle mode.

Is your spindle encoder showing any errors on the PID screen?

post a fresh report.zip

I have attached report.