Hello cnckeith;
I will add a 0.1uf cap to the output and check again and if you say that it does not concern the rigid tapping, I will be ok with that.
I forgot to mention that I also tried another pc with the same results.
I did go through all of the above mentioned tb's and videos and changed the nic to 100mhz full duplex
https://photos.google.com/album/AF1QipM ... u58CQGDpP0
Trak Mill Rebuild
Moderator: cnckeith
-
- Posts: 31
- Joined: Fri Jun 17, 2022 3:20 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: cnc12 Mill Pro E0623483321F-0412225912,CNC Router Pro E0623479658B-1022203857
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Mass
- Contact:
-
- Posts: 31
- Joined: Fri Jun 17, 2022 3:20 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: cnc12 Mill Pro E0623483321F-0412225912,CNC Router Pro E0623479658B-1022203857
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Mass
- Contact:
Re: Trak Mill Rebuild
the pc is a lenovo tinkcentre I5 6500T 2.5ghz 4 cores, 4 treads and single treads rating of 1791 not that great but above the 1500.
-
- Posts: 31
- Joined: Fri Jun 17, 2022 3:20 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: cnc12 Mill Pro E0623483321F-0412225912,CNC Router Pro E0623479658B-1022203857
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Mass
- Contact:
Re: Trak Mill Rebuild
Good Afternoon All;
Totally re installed windows 10 pro starting with formatting the drive and all works now no errors on the com_stress_test. This is great, thanks a lot guys for the help
Totally re installed windows 10 pro starting with formatting the drive and all works now no errors on the com_stress_test. This is great, thanks a lot guys for the help