constant fault after update to 5.08 <resolved, wizard not configured properly>

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
cnckeith
Posts: 7334
Joined: Wed Mar 03, 2010 4:23 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
CNC Control System Serial Number: none
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
Contact:
Contact cnckeith

Re: constant fault after update to 5.08

Post by cnckeith »

Rawfodog wrote: ↑Sat Feb 03, 2024 4:04 pm Thanks. I will make the changes.

Unrelated question but is there a development environment available for CNC12?
Something to use for testing without being physically connected to the hardware?
no really. half the code lives on the board, so cnc12 needs to be connected to a control board. so answer is, buy an acorn for bench testing/development
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
Top
Post Reply

Return to “Centroid Acorn CNC Controller”