Spindle bench test not showing full text

PhilipTrueman · Post by **PhilipTrueman** » Wed Jan 31, 2024 2:10 pm

The spindle benchtest does not show the full text. Maybe it needs adjusting in the software or is it my monitor resolution?

Post by **cnckeith** » Wed Jan 31, 2024 5:30 pm

you are looking at the g code preview, run the job by pressing cycle start to run the spindle benchtest

PhilipTrueman · Post by **PhilipTrueman** » Thu Feb 01, 2024 12:16 pm

cnckeith wrote: ↑Wed Jan 31, 2024 5:30 pm you are looking at the g code preview, run the job by pressing cycle start to run the spindle benchtest

YES but if you look at the right hand side of the text there are words missing at the end of each line.

suntravel · Post by **suntravel** » Thu Feb 01, 2024 12:26 pm

Click Edit to read the full text.

Uwe

PhilipTrueman · Post by **PhilipTrueman** » Fri Feb 02, 2024 5:05 am

suntravel wrote: ↑Thu Feb 01, 2024 12:26 pm Click Edit to read the full text.

Uwe

Thanks Uwe
All it needs is for centroid to move the text to the left by 2cm.

suntravel · Post by **suntravel** » Fri Feb 02, 2024 5:59 am

No.

Text is longer and there are more than 11 lines with infos.

It is a preview not more, for full read, use editor.

That is the way it is.

Uwe

Centroid Community CNC Support Forum