My Wizard fails to launch! (resolved)

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

diycncscott

Re: My Wizard fails to launch!

Post by diycncscott »

Are you both running Windows 10 64 bit?

Are you saying it ran fine until you re-installed it the CNC12 software?

Is CNC12 shut down?

Are you trying to run the Wizard from the shortcut on the desktop or from the start menu?

Do you have only Mill installed? (Not both) Have both Mill and Lath EVER been installed?

Yes, I Teamviewer session would be very helpful. Please call or email us with your Teamviewer ID and pw. If you don't have a Teamviewer id, you're not connected to the internet.
RGSparber
Posts: 150
Joined: Sat May 27, 2017 2:12 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: 38D269533454-0111180523
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
Location: Phoenix, AZ
Contact:

Re: My Wizard fails to launch!

Post by RGSparber »

I sent team viewer info to Keith.
cnckeith
Posts: 7164
Joined: Wed Mar 03, 2010 4:23 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
CNC Control System Serial Number: none
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
Contact:

Re: My Wizard fails to launch!

Post by cnckeith »

got it and TV'd in.. fixed! not sure what it was but we installed fresh and its working.. Teamviewer is a great support tool! everyone should have it on their CNCPC
tv session.JPG
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
Post Reply