Help with Wiring ATC components Needed Please Help

[Blaze]

Hello Folks, I hope all is well. A new comer here! I have tried researching to find answers to my issue with no success. I am therefore left with asking for help on this forum once again. I'll appreciate any guidance.
I have a 5-axis wood router that I have been working on retrofitting with Acornsix. I currently have everything wired up and working, with the exception of the 6-rack ATC. Due to my lack of knowledge and inexperience, other than knowing what the physical movement should look like when the machine executes an M06 command, I find it difficult to make these connections.

I have traced and can positively identify all the wires coming from the machine to the cabinet. There are about 14 wires.
The machine came configured with a 5-axis RichAuto controller and a GDL60 24z-6.0 spindle, which has about 8 spindle terminal wires. (Please see photo.)

GDL60_6.0KW_ATC_Air-Cooled_Spindle_Wiring_Reference.pdf

GDL60_6.0KW_ATC_Air-Cooled_Spindle_Wiring_Reference.

(513.42 KiB) Downloaded 5 times

GDL60-24Z6.0 ATC Spindle Terminal.

Spindel terminal pinout.

2 pneumatic valve sensors with 2 wires each.

Pneumatic t Air valve PRSPC Model 5v210-08.

Pneumatic t Air valve PRSPC Model 5v210-08 wiring.

1 Reed switch that has two wires. I believe this reed switch monitors my dust boot positions.

Pneumatic Reed Switch Model KT-11R.

I have also included the old wire with the RichAuto controller.

white wire connected to relay.

Wire traced from Spindle terminal to RichAuto Controller And relay (5)

A simple schema will get me started as I continue to learn.
I appreciate any help, advise or guidance

[cnckeith]

make a online photo album and populate with lots of hi res photos of the machine, control, ATC etc.
i suggest google photos, and post link to photo album here.

[Blaze]

I have added the best pictures my phone can take to a google Album. Here is the link. Thanks in advance.
https://photos.app.goo.gl/VU5pi8Q6pmTr12ha7

[cnckeith]

thanks.. please take some more photos of the machine and add to the album, need to see what the tool changer looks like. and the machine too!

[Blaze]

I hope the picture added will suffice. i am out on travel and won't be back home for a couple of days. there are the picture i found on my cell phone. Here is the lin. https://photos.app.goo.gl/VU5pi8Q6pmTr12ha7
it's a 6 Fork clamping tooling