I have had a working system and after a few modifications and some time off I tried to run several files and all stop at line 12 => G70G91.1.
I'm new at this and don't have a clue. I looked up G70 and says Metric.
My machine started out as an Avid Pro 4' X 8'. I have cClearpath servos on all axis, Acorn board and Eth1616 with motor faults lines going to 4 inputs on the eth 1616 board, Hitachi 11kw inverter, and a Colombo 5.5 spindle. It has run fine and has run several projects. I would appreciate any ideas on how to get past this issue.
Martin G Hood
Won't run past Line 12=> Gg70G91.1
Moderator: cnckeith
Re: Won't run past Line 12=> Gg70G91.1
Where did you look up G70?
What do you expect G91.1 to do?
Here is the Centroid Mill Operator's Manual:
https://www.centroidcnc.com/centroid_di ... -v4.20.pdf
See Chapters 11, 12 and 13 for supported CNC codes.
Try using a Centroid or Fanuc or Haas postprocessor (but not a Centroid CNC4 postprocessor; CNC4 was an earlier generation stepper control, from the late 1980's and early 1990's, that has little in common with CNC12).
What do you expect G91.1 to do?
Here is the Centroid Mill Operator's Manual:
https://www.centroidcnc.com/centroid_di ... -v4.20.pdf
See Chapters 11, 12 and 13 for supported CNC codes.
Try using a Centroid or Fanuc or Haas postprocessor (but not a Centroid CNC4 postprocessor; CNC4 was an earlier generation stepper control, from the late 1980's and early 1990's, that has little in common with CNC12).
-
- Posts: 7334
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Won't run past Line 12=> Gg70G91.1
post the offending g code program (where/how was it generated) and a fresh report.zip
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html