Help wiring Minarik NGR Drive.

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
Andre
Posts: 4
Joined: Sat May 07, 2022 9:48 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: 5933
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: Yes

Help wiring Minarik NGR Drive.

Post by Andre »

I’m in the process of converting a small milling milling machine too centroid. I’m using a minarik 4 quadrant drive with PCM isolation board for the 180vdc spindle motor. The speed is straight forward. But not sure how to wire the direction. The manual says short common to Dir terminal. So I assume I only need to use one output realy and assign it as VFD direction? Any help would be appreciated.

https://pim.galco.com/Manufacturer/Mina ... -4q_um.pdf
Attachments
3A893E3F-53BC-4E2A-B61A-062BA5AD2DA1.png
Post Reply