acorn with an old shopbot
Moderator: cnckeith
-
luke
- Posts: 71
- Joined: Wed Jan 25, 2023 11:53 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: No
- CNC11: No
- CPU10 or CPU7: No
Re: acorn with an old shopbot
I got the 65 volt supply in and running. After that was all working I installed cnc 5.06 and after a few problems like it not holding all the settings I got it to work. Couldn't understand why the z wasn't working and had to reset the numbers in the config as that was what wasn't holding had to write the proper speeds and settings 3 times before they held. Now it is working as good as 4.82
-
luke
- Posts: 71
- Joined: Wed Jan 25, 2023 11:53 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: No
- CNC11: No
- CPU10 or CPU7: No
Re: acorn with an old shopbot
One other thing I notice is when I home it seems to move a lot slower then it did with 4.82
-
Nigelo
- Posts: 370
- Joined: Tue Dec 11, 2018 4:03 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: F045DA80C8B8-0905181172
E415F6F70BC3-0318203049
98F07B91FC6B-0123236802 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: UK
Re: acorn with an old shopbot
Sounds like you are using the default speeds. In v5.06 go into the Wizard Homing and Travel section where you specify homing speeds required for each individual axis
Hope this helps
Nigel
"You can lead a horse to water but you cannot force it to drink"
Nigel
"You can lead a horse to water but you cannot force it to drink"
-
luke
- Posts: 71
- Joined: Wed Jan 25, 2023 11:53 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: No
- CNC11: No
- CPU10 or CPU7: No
Re: acorn with an old shopbot
I saw that I did bump it up to a better speed