ATC Problem after update
Posted: Thu Jan 26, 2023 10:15 pm
I updated a 6 x 12 Router with a ATC. All was working before the update but after the update the tool changer started acting erratically. It would move to the pocket deposit the tool but instead of retracting and moving to the next tool it simply moved to the left or right without clearing the tool beside the one it just deposited.
After the update I installed the Pro License and loading the working Drive set up shutdown and restarted as required. After checking the Mfunc6 file it still did not work. I installed a know working mfunc6 File and was able to get the tool changer to work as before. However it would only work for 3 or 4 tool changes did not matter which tool was called up I would Give a 913 could not open file error. The fix for this was to reinitiate the ATC and each time after doing this the tool changer would work for 3 or 4 tool changes and then error out again and after each error the tool check function did not work but I was able to jog z with no problem. I use this set up on other Routers with no problem so I am not sure what might be causing this issue I do have the Swissi Program for this control but it is not installed just the standard Mfunc6 finger no orientation macro
Attached is a picture of the error screen and the last report.
After the update I installed the Pro License and loading the working Drive set up shutdown and restarted as required. After checking the Mfunc6 file it still did not work. I installed a know working mfunc6 File and was able to get the tool changer to work as before. However it would only work for 3 or 4 tool changes did not matter which tool was called up I would Give a 913 could not open file error. The fix for this was to reinitiate the ATC and each time after doing this the tool changer would work for 3 or 4 tool changes and then error out again and after each error the tool check function did not work but I was able to jog z with no problem. I use this set up on other Routers with no problem so I am not sure what might be causing this issue I do have the Swissi Program for this control but it is not installed just the standard Mfunc6 finger no orientation macro
Attached is a picture of the error screen and the last report.