Taizhou servo question

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
danno067
Posts: 11
Joined: Sun Nov 27, 2022 11:59 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No

Taizhou servo question

Post by danno067 »

Need some help on this one. In the attached pic, I wired pin 6 ( servo enable input) to the enable pin on the screw terminal of the Acorn board. But the servo will only run if I supply 24v to pin 11 on the driver. Should pin 11 go to the screw terminal? If so what about pin 6?
AAservousermanualv6_3_221201_120103_29.jpg
AAservousermanualv6_3_221201_120103_28.jpg
AAservousermanualv6_3_221201_120103_38.jpg
Post Reply