Taizhou servo question
Moderator: cnckeith
-
danno067
- Posts: 11
- Joined: Sun Nov 27, 2022 11:59 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Taizhou servo question
Need some help on this one. In the attached pic, I wired pin 6 ( servo enable input) to the enable pin on the screw terminal of the Acorn board. But the servo will only run if I supply 24v to pin 11 on the driver. Should pin 11 go to the screw terminal? If so what about pin 6?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)