I just want to make sure I have the axis configuration set up correctly in centroid acorn. I have a Bridgeport Series I mill with a 2 on 1 ration with DMM 750 Servos/DYN4 drivers. I have attached a photo of the settings but just in case you can’t open the file this is the settings.
Steps/Revolutions-8000
Overall turns per ratio-10
Max rate-50
Fast job–50
Slow jog–10
Any help would be greatly appreciated,
James
Axis configuration
Moderator: cnckeith
-
- Posts: 1
- Joined: Wed Nov 23, 2022 8:42 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 98F07B461D8E-0601226262
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
-
- Posts: 7166
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Axis configuration
looks good, nice conservative numbers to get things going. start a photo album of your project post link here and post a fresh report.zip so we can see your current settings.
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html